Skip to main content

12V / 15V 200w AC Multi-Tap Magnetic Outdoor Rated Transformer - PTX-EPC200W

AQLIGHTING

MSRP: $129.99
$113.99
(You save $16.00 )
(1 review) Write a Review
SKU:
PTX-EPC200W
Weight:
11.00 Ounces
Adding to cart… The item has been added
Power your low voltage lighting system without breaking the bank; introducing the PTX-EPC200w multi-tap AC transformer from AQL, this outdoor rated transformer can operate fully autonomously (after initial setup) due to built in photocell and hour timers. Capable of supplying up to 200w, the PTX-EPC200W is perfect for large draw systems, especially LED landscape or pond lighting applications. Crafted from steel and powdercoated black to better blend with the environment, the PTX-EPC200W has a 6' grounded plug and boasts multiple knockouts for wiring access and for wall/surface mounting. For a secondary line of protection for your lights, this magnetic transformer has a thermally tripped circuit breaker to protect itself from overloads. The PTX-EPC200W is suitable for wet locations as it is both ETL and cETL listed.
Material Powder Coated Steel
Input Voltage 120V 60Hz 0.33A
Output Voltage 12V AC/ 15V AC
Core Type Magnetic
Capacity 200w Max
Controllers Built-in Photocell & Hour Timer
Protection Thermal Circuit Breaker
Dimensions 11.35" X 4.05" X 4.05"
Certifications ETL/cETL Listed for Wet Locations / Outdoor Rated
1. TIMER ON - TIMER OFF:
A. Set three position switch to HI or LOW position.
B. Push in all trippers on dial between desired 'ON' time.
C. Turn dial clockwise until time arrow is pointing at correct time of day.

2. AUTOMATIC CONTROL WITH PHOTOCELL:
A. Remove protective cover from photocell.
B. The HI or LOW position on the three position switch will activate both the timer and the photocell. To control lights - set the timer to turn on before dark and the photocell will activate the lights when it gets dark. Lights can be turned off by the timer at the pre-set time, or push in all trippers and photocell will turn off lights at dawn.

3. CIRCUIT BREAKERS:
A. A circuit breaker will trip oif there is a short or if total lamp wattage installed exceeds rating.
B. To reset breaker - turn breaker to 'ON' position.
C. If breaker trips again, check for an overload or a short circuit.

4. NOTES
Photocell has a delay up to 60 +40/-20 seconds.

Click to view instructions

1 Review Hide Reviews Show Reviews

  • 4
    PTX-EPC200W

    Posted by Jim on Aug 16th 2019

    Just what my customer wants. I would like just a little bit more room to get the wire into the terminals.